+ Reply to Thread
Page 1 of 2 12 LastLast
Results 1 to 10 of 12

Thread: Deep freeze and sap production.

  1. #1
    Join Date
    Jan 2014
    Location
    wolcott, ct
    Posts
    62

    Default Deep freeze and sap production.

    I have a question for all out there. I tapped roughly 10 days ago and have made roughly 2 gallons of syrup so far. However, with the warmth last week and now the cold later this week the sap flow will greatly decrease. Should I change my taps because of this? Thanks for the feedback. Kevin

  2. #2
    Join Date
    May 2009
    Location
    UVM Proctor Maple Research Center, Underhill Ctr, VT
    Posts
    6,484

    Default

    Quote Originally Posted by khuberpt View Post
    I have a question for all out there. I tapped roughly 10 days ago and have made roughly 2 gallons of syrup so far. However, with the warmth last week and now the cold later this week the sap flow will greatly decrease. Should I change my taps because of this? Thanks for the feedback. Kevin
    No, don't bother changing your spouts. I assume that you're using buckets? If so, depending upon how long it is before it warms up again and how fast it warms up, you might see a reduction in yield due to taphole drying. Nothing much you can do about it at this point.
    Dr. Tim Perkins
    UVM Proctor Maple Research Ctr
    http://www.uvm.edu/~pmrc
    https://mapleresearch.org
    Timothy.Perkins@uvm.edu

  3. #3
    Join Date
    Jan 2014
    Location
    wolcott, ct
    Posts
    62

    Default

    Yes I am using buckets. If the tap holes dry out too much should I then consider re-tapping? Thanks.

  4. #4
    Join Date
    Dec 2002
    Location
    Rock Creek, NC
    Posts
    5,807

    Default

    A prolonged freeze won't hurt your production like a warm spell will. I think you will still get plenty of sap when it starts running again. Normally with new or sterilized taps a hole will stay open for 4 weeks or a little longer.
    Russ

    "Red Roof Maples" Where the term "boiling soda" was first introduced to the maple world!

    1930 Ford Model AA Doodlebug tractor
    A couple of Honda 4 wheelers
    Four chainsaws and no chickens!

  5. #5
    Join Date
    May 2009
    Location
    UVM Proctor Maple Research Center, Underhill Ctr, VT
    Posts
    6,484

    Default

    Quote Originally Posted by khuberpt View Post
    If the tap holes dry out too much should I then consider re-tapping? Thanks.
    No. Retapping would double the wound to the tree. You'll be fine for a month or so, perhaps longer if you used new or cleaned spouts. Your other recourse would be to find more trees.
    Dr. Tim Perkins
    UVM Proctor Maple Research Ctr
    http://www.uvm.edu/~pmrc
    https://mapleresearch.org
    Timothy.Perkins@uvm.edu

  6. #6
    Join Date
    Feb 2012
    Location
    Middlebury, Connecticut
    Posts
    93

    Default

    I tapped 30 trees on Sunday in Middlebury, CT when it was warm and I had an instant flow.

    I am sure the cold snap over the next fews days will slow things down a bit...and then things will start flowing again ....that is the life of a Mapleir.

    SO HAPPY MAPLING EVERYONE!
    19-21 Back to tapping
    17-18: not able to tap
    14-16 present: Portable Oil Tank evaporator 40+ taps
    09-14: Stove to Barrel - 20 taps

  7. #7
    Join Date
    Jan 2015
    Location
    Missouri
    Posts
    92

    Default

    Oh, I was under the impression that a tap would produce for up to 12 weeks. Is the number closer to 4 weeks? If so, I'll need to adjust my strategy next year.

  8. #8
    Join Date
    Jan 2014
    Location
    Upstate NY
    Posts
    185

    Default

    You should get longer than 4 weeks. I know I have only been doing this four 5 years but I used to hang buckets and I got 2 months at the least. Last year I tapped mid February and it ran all the way into April. This year I have went to gravity tubing and I have been tapped for 10 days also. One of the reasons why I tapped early was because people say you can go longer with tubing. I may be wrong but lets hope not.

  9. #9
    Join Date
    Jan 2014
    Location
    wolcott, ct
    Posts
    62

    Default

    I am hoping the flow returns early next week. This deep short freeze should not be to bad as we have had a mild winter here in western Ct. The initial flow was great until the crazy El Niño weather pattern changed. I should wrap the trunks with warming blankets!

  10. #10
    Join Date
    May 2009
    Location
    UVM Proctor Maple Research Center, Underhill Ctr, VT
    Posts
    6,484

    Default

    Quote Originally Posted by Ray_Nagle View Post
    Oh, I was under the impression that a tap would produce for up to 12 weeks. Is the number closer to 4 weeks? If so, I'll need to adjust my strategy next year.
    The length of the flow season depends mostly on spout sanitation (cleaner=longer), but also on the weather (hotter=shorter), and technology (gravity=shorter, vacuum=longer).
    Dr. Tim Perkins
    UVM Proctor Maple Research Ctr
    http://www.uvm.edu/~pmrc
    https://mapleresearch.org
    Timothy.Perkins@uvm.edu

+ Reply to Thread
Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts