Thanks Mark I will have to check. Although it has been working great I had fixed about every big leak I had except for a couple very tiny ones at a couple saddles as soon as I tapped i walk my mainline justabouteveryday when pump is on to try and catch any major issues. . Even when I first tapped and turned the pump on it would hold some vac and I could tell it was working. Now I went and pulled the loop at my 1st saddle which is about 25ft from the releaser and I get nothing no change the way the releaser acts it just kind of stutters . I'll have to tinker with it more and see what happens
Quote Originally Posted by markcasper View Post
There needs to be some added weight on top of the existing weight (washer) when running higher than 15". Additionally, it sounds to me like you have some major leaks back in the woods which is causing it to act in the manner you describe. If your pulling in air from leaks the jar can't hold enough vacuum causing it to bobble, at least thats what I found when I used to use them. You need to have a person at the releaser to reset it/dump it manually while you go fix the leaks. They also don't like to work and will freeze up with high moisture in the air, even well above freezing b/c vacuum freezes up at a higher temp. A candle underneath or some kind of heat source blowing on it helps with this problem. nKeep in mind that you probably will top out at 19-20" of vacuum tops using these because of their continual hissing of vaccum away.

Also, I hope you have a trap between the pump and releaser? check and make sure your trap, vacuum tank on the pump, and line between all are clear of liquid, otherwise this can cause the same problem for any releaser, even the factory ones. Hope this helps.