Send me measurements, width and length, I might be able to help. I have one that I took off my 3x8 Grimm arch back when I bought new pans. I wasn't savvy to the fact that Leader lies about their sizes. I had a 3x6 flue pan with a tag saying it was 3x6, and a syrup pan tagged 3x2 for 8' or 96" total length. I ordered Thor custom pans, 3x3 and 3x5, mistakenly thinking it would fit. When I set the flue pan where it had to go, the syrup pan was 1.5" too long. I measured the pans, each were exactly what I had ordered. I then had to remove the casting for the base stack and build a new one, that fit the same base stack but had less space all around the 4 sides. I made it out of 1/4" steel and angle iron. with a stack collar of 1/8" flat stock standing up. It has worked perfectly, I have the old one in like new condition leaning against a tree next to the sugarhouse. I can't help with the front. Leader does sell new air tight fronts, that might be an option.
With the dimensions I can see if it will fit your needs. From there we can talk.
Last edited by maple flats; 04-01-2021 at 07:57 PM.
Dave Klish, I recently bought a 2x6 wood fired evaporator from A&A Sheet Metal which I will be converting to oil fired
Now have solar, 2x6 finish pan, 5 bank 7x7 filter press, large water jacketed bottler, and tankless water heater.
Recently bought another Gingerich RO, this one was a 125, but a second membrane was added thus is a 250, like I had.
After running a 2x3, a 2x6, 3x8 tapping from 79 taps up to 1320 all woodfired, now I'm going to a 2x6 oil fired and a 200-425 taps.
Reply With Quote
