Cleaning 3/16 Tubing

**Gallinipper** · 12-12-2016, 11:24 PM

I am curious how most of you are cleaning 3/16 tubing? I have read past studies that indicate there is not much difference between using water vs. chemicals. I know that many of you use pulsing air and water. I heard that some large producers are moving away from pulsing water and air. If so, why and what are your current practices. Some are using low pressure water only. Others low pressure water and blowing them down following. Some are just blowing them down with compressed air and many do nothing at all. Thoughts on the subject? What is the most cost and time effective? For those of you blowing them down or not doing anything at all, are you finding any issue with clogged T's or tubing with the small diameter of 3/16? For those using water any issue with mold or algae? With my number of taps growing, I don't plan to pull the lines out after ever season any longer and plan to keep them in the woods. I am looking for best practices based on experience with the 3/16 line over a course of several years of being in the woods.

**motowbrowne** · 12-13-2016, 07:52 AM

I'm no expert by any means, but I started at the top with a child gallons of water in a bucket. Pulled a tap, stuck it in the bucket to suck up some water, then stuck the tap onto the peg to seal it. And down the line I went. At the end I came back and unplugged all the taps so the drops would dry out. Seemed to work pretty good. Didn't cost me anything or take much time.