I think it's specific to IBCs.
Easiest to use a FernCo fitting from the hardware store (black rubber with hose clamps) and then a pvc fitting to adapt to whatever size you like.
I think it's specific to IBCs.
Easiest to use a FernCo fitting from the hardware store (black rubber with hose clamps) and then a pvc fitting to adapt to whatever size you like.
Second the fernco suggestion, dont waste your time looking for fittings that will cost a lot more than a fernco to PVC connection.
CDL 2x8
Around 4000 taps
Polaris ATVs, Ski Doo snowmobiles to get around
Atlas Copco pumps
Lapierre two post RO
http://s272.photobucket.com/albums/j...Sugar%20shack/
Ok Fellas thanks, will look into FernCo fittings
~John Deere 750 4x4 /w65 loader~
~ 20" X 66" Maple Pro *7" drop flues~
~ 12 x 12 sugar shack~
~150+ taps old school~2011
~130+ taps for 2014~
~6x4 Gator~
Hinkjc Mountain Poultry
I use alot of these tanks with the fernco and PVC ,never had a problem ! Jim L.
3x10 Dallalre, oil fired, Stainless steel.
Steam hoods front and rear with preheater.
1500 taps on vac, right to sugar house.
900 on Gravity
New Busch 3 Phase Vacuum. (2010)
Lapierre 600 Turbo with 2 - 8" posts
36 years of MAPLE ENJOYMENT!!
https://www.facebook.com/pages/Hills...93710737313171
Good to know no problems with these fittings. think a 3.5" or 4" fitting would work and fit over the treads on this?
~John Deere 750 4x4 /w65 loader~
~ 20" X 66" Maple Pro *7" drop flues~
~ 12 x 12 sugar shack~
~150+ taps old school~2011
~130+ taps for 2014~
~6x4 Gator~
Hinkjc Mountain Poultry
I think what you are looking for is a butress thread, you can find them online, here is a link http://www.jmesales.com there is tons of sites just do search. I've done the fernco thing it works great to
Last edited by jcb; 11-04-2010 at 04:12 PM.
3 1/2 x 10
2000 taps
Kubota 4610
http://s1090.photobucket.com/albums/i370/jcb66/
www.countrymaplefarms.com
https://www.facebook.com/CountryMapleFarms