Working on a Water Reduction Unit "WRU" for the old 3 x 10 ( 3 x 5 foot flue pan).
I got started on this and here are some shots. This is in the very early stages so any suggestions may be helpful. Currently I have the four sides roughed out with some stiffeners added to the top and bottom all around which will become condensate channels.
The stainless that I an using is from the liner on Dari- Kool bulk tank. Heavy and difficult to bend real crisp corners.
Lots of work to do on this to be ready for 2010!
Thanks to all traders that have got me this deep into this project!
The hood on top of the WRU is the current rear pan hood, which I plan to use on top of the WRU. I just set the front hood on the table in front of the WRU box to see what it might look like.
The WRU size is 21 inch high, 38 inches wide, and 59.5 long.
Might add another 30-40 GPH to the old girl!!
Did you know you can use duct tape as temporary clamps
Regards,
Chris