Try just blowing air on it with a small fan.
Try just blowing air on it with a small fan.
1000 taps on vac down to 100+ buckets 99% sugars
2x5 SL Hi-Output Raised Flue Corsair evaporator
SL Short bank press with CDL diaphragm pump
Leader Micro 1 RO for 2024
Constantly changing
2010:36 gal 2011:126 gal 2012:81 gal 2013:248 gal 2014: 329.5 gal 2015:305 gal 2016:316 gal 2017:258 gal 2018:147 gal 2019:91 gal 2020:30 gal 2021:30 gal 2023:50 gal Total since 2010: 2047.5 gal
Tapping the same trees my great, great and great grandfathers tapped.
You may also want to put the "chicken light" on a thermostat. It might be adding too much heat when it's warmer outside.
Dave Klish, I recently ordered a 2x6 wood fired evaporator from A&A Sheet Metal which I will be converting to oil fired
Now have solar, 2x6 finish pan, 5 bank 7x7 filter press, large water jacketed bottler, and tankless water heater.
Recently bought another Gingerich RO, this one was a 125, but a second membrane was added thus is a 250, like I had.
After running a 2x3, a 2x6, 3x8 tapping from 79 taps up to 1320 all woodfired, now I'm going to a 2x6 oil fired and a 200-425 taps.
I'd move the pump outside the box and in an open-sided structure for better air-flow and cooling. Also get one of those thermostat blocks that come on when the temps fall below 40 deg F for the chicken light. That'll keep your pump cooler and prevent overheating, but also keep the pump warm for easier start-ups.
Dr. Tim Perkins
UVM Proctor Maple Research Ctr
http://www.uvm.edu/~pmrc
https://mapleresearch.org
Timothy.Perkins@uvm.edu
I've haven't had issues with the Gould's transfer pump. There are enough "vents" with the holes for the hoses. I was just concerned about putting the rotary vane pump outside because of "warm up" and possible water in the pump freezing. But it sounds like the best idea so far. Thanks all.
King 2x6 with Steam-Away
16x34 Sugarhouse
460 on Vac
I thot this was supposed to be a hobby
I've haven't had issues with the Gould's transfer pump. There are enough "vents" with the holes for the hoses. I was just concerned about putting the rotary vane pump outside because of "warm up" and possible water in the pump freezing. But it sounds like the best idea so far. Thanks all.
King 2x6 with Steam-Away
16x34 Sugarhouse
460 on Vac
I thot this was supposed to be a hobby