+ Reply to Thread
Results 1 to 2 of 2

Thread: valve in pot

  1. 03-11-2021, 04:44 PM #1
    Brien
    Brien is offline Maple Enthusiast Brien is on a distinguished road
    Join Date
    Feb 2021
    Location
    North Bay Ontario
    Posts
    76

    Default valve in pot

    I decided to try and silver solder a fitting into a Stainless Steel pot. I'm going to use this as a warmer before it goes into the pan. I watched a video on youtube, the only thing I changed was I made my own drift bar to draw through the stainless so I would have a bigger lip. Ordered the Harris silver solder and flux off amazon. and soldered on with success. The drift bar I made up on a lathe. Pretty happy with the results
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 03-11-2021, 05:01 PM #2
    maple flats's Avatar
    maple flats
    maple flats is offline Super Moderator maple flats will become famous soon enough
    Join Date
    Jan 2006
    Location
    Oneida NY
    Posts
    11,566

    Default

    Nice looking job, Good work!
    Dave Klish, I recently ordered a 2x6 wood fired evaporator from A&A Sheet Metal which I will be converting to oil fired
    Now have solar, 2x6 finish pan, 5 bank 7x7 filter press, large water jacketed bottler, and tankless water heater.
    Recently bought another Gingerich RO, this one was a 125, but a second membrane was added thus is a 250, like I had.
    After running a 2x3, a 2x6, 3x8 tapping from 79 taps up to 1320 all woodfired, now I'm going to a 2x6 oil fired and a 200-425 taps.
    Reply With Quote Reply With Quote
+ Reply to Thread
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules