What is anyone using to seal a pump wire through the wall of a releaser or pump chamber?
What is anyone using to seal a pump wire through the wall of a releaser or pump chamber?
William
950 taps
3 X 12 Thor pans on a Brian Arch
CDL 600 expandable
It's been so long since I built my releaser, I forget what it's called, but I think it's a marine cable seal. Mine screws into the side of the releaser, and it has a hole with a compression gland on it. Pass the cable through, and tighten the nut on the gland. Below is something similar to what I have.
https://www.amazon.com/Ancor-765002-..._t1_B000NI5EXW
Josh
2009 - 370 on vac. & 16 buckets
2010 - 377 on vac.
2011 - 590 on vac.
2012 - 620 on high vac., 170 buckets, 110 on gravity tubing
2013 - 830 mine + 800-1000 others
2014 - 870 mine + 800-1000 others
2017 - 920 mine + 500-700 others
2018 - 902 mine + 500-700 others
2019 - 902 mine + 700 others
2020 - 902 mine + ???? others
Atlas Copco Pump
2.5'x8' 802maple Special with Dallaire pans
H2O Innovation 600gph RO
Spring Harvest Website
I used a similar type fitting but ended up putting a wad of plumbers putty around the wires as well to give it a 100% seal.
2.5X10 HE
600 RO
Vac