+ Reply to Thread
Results 1 to 4 of 4

Thread: Gas powered vacuum pump

  1. #1
    Join Date
    Jan 2013
    Location
    ohio
    Posts
    106

    Default Gas powered vacuum pump

    Interested in recommendations for best gas powered vacuum pump.

  2. #2
    Join Date
    Feb 2012
    Location
    Northern Vermont
    Posts
    26

    Default

    How many taps are u looking at? I run two different Airablo setups: 60cfm 202 head with Honda GX290 and a 80cfm 302 head with Honda GX390. Need sufficient amount of taps and good woods to justify the gas/operating cost.

  3. #3
    Join Date
    Jan 2013
    Location
    ohio
    Posts
    106

    Default

    Will have about 2000 taps with very minimal slope

  4. #4
    Join Date
    Jan 2006
    Location
    Oneida NY
    Posts
    11,566

    Default

    Back when I had gas powered vacuum pumps I had 2 systems on them, each about 750 taps at times. I used Honda engines. The 6.5's did ok, but I then swapped one out to a 9 hp and it used less fuel on the same system. You will want to set up with a larger gas tank than they come with. I hooked 2 @4.5 gal tanks together. You will likely need a 20 gal minimum. How will it be hauling fuel in? One of mine was just 40' off the road, the other was 950', up about 15', then go thru a boggy swamp for the last 350 feet. No way to haul it in when the snow got deep, I carried 2@ 2.5 gal each for a balanced load. No snowmobile at that time, when I got one later on, it often couldn't handle the deep snow, on snow up to about 1' no problem., deeper with big drifts no way.
    Dave Klish, I recently ordered a 2x6 wood fired evaporator from A&A Sheet Metal which I will be converting to oil fired
    Now have solar, 2x6 finish pan, 5 bank 7x7 filter press, large water jacketed bottler, and tankless water heater.
    Recently bought another Gingerich RO, this one was a 125, but a second membrane was added thus is a 250, like I had.
    After running a 2x3, a 2x6, 3x8 tapping from 79 taps up to 1320 all woodfired, now I'm going to a 2x6 oil fired and a 200-425 taps.

+ Reply to Thread

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts