+ Reply to Thread
Results 1 to 3 of 3

Thread: No industry standard in end tees?

  1. #1
    Join Date
    Feb 2011
    Location
    Eagle lake Maine
    Posts
    280

    Default No industry standard in end tees?

    I was surprised when replacing 1000 drops this season to find that the red end tees I bought are designed to loop around the right side of the tree. The brand I used previously were red and were made to loop around the left side and blue or green went around the right. There's not an industry standard apparently, not a real big deal but......

  2. #2
    Join Date
    May 2009
    Location
    UVM Proctor Maple Research Center, Underhill Ctr, VT
    Posts
    6,414

    Default

    Industry standard...in maple?
    Dr. Tim Perkins
    UVM Proctor Maple Research Ctr
    http://www.uvm.edu/~pmrc
    https://mapleresearch.org
    Timothy.Perkins@uvm.edu

  3. #3
    Join Date
    Mar 2005
    Location
    Albion PA
    Posts
    5,099

    Default

    I have seen both left and right end Tees. I assume these are the blind tees? Yes all custom plastic. from each suppliers. Because each one is better than the other!
    Pick fittings that work for you and your system. I like to uses the same brand Tee and spout, so they plug together during the off season. Some end tees from CDL did not have cups on the tee.
    Good luck hope your season is good.
    Keep boiling!
    Regards,
    Chris
    Casbohm Maple and Honey
    625 roadside taps + Neighbors bring some sap too!
    3x10 King, WRU, AOF and AUF
    12" SIRO Filter Press.
    2015 Ford F250 PSD sap hauler
    One Golden named Maggie, Norwegian Forest Cat named Lucy
    Too many Cub Cadets
    Ford Jubilee and several Allis WD's, and IH tractors
    1932 Ford AAB ton and a half, dump truck

    www.mapleandhoney.com

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts