+ Reply to Thread
Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: Hobart Mixer

  1. #11
    Join Date
    Mar 2012
    Location
    Walpole, NH
    Posts
    1,097

    Default

    Ragged View, check this one out. https://nh.craigslist.org/bfs/d/mirr...112267157.html
    Also, if you are on Facebook check out the marketplace, because there is quite a few in the $12-1800 range.
    Sugaring for 45+ years
    New Sugarhouse 14'x32'
    New to Me Algier 2'x8' wood fired evaporator
    225 Sugar Maples Currently,(105 on 3/16" and 110 on Shurflo 4008 vacuum, 10 gravity), (16,000 before being disabled)
    1947 Farmall H and Wagon with gathering tank
    2012 Kubota with forks to move wood around

  2. #12
    Join Date
    Feb 2009
    Location
    Andover,NH
    Posts
    40

    Default

    Thanks, will do
    Mark Cowdrey
    Ragged View Farm
    111 Bradley Lake Road
    Andover, NH

    In the Spring of '15, after boiling with Eric Johnson of Tucker Mountain Maple for 10 years, we began boiling the sap from our 3-400 taps here. I bought my rig from Eric, a 2-1/2 X 8 raised flue on a custom air-injected wood-fired arch. We put our syrup up in glass and sell til we run out. We are not using vacuum, an RO or filter press.

    www.raggedviewfarm.com

  3. #13
    Join Date
    Mar 2005
    Location
    Albion PA
    Posts
    4,922

    Default

    No it should not take that long.
    About 5 minutes to the point the steam burst happens then made 15 minutes of stiring to cool down and done. Of course depends on the batch size.
    Regards,
    Chris
    Casbohm Maple and Honey
    600 roadside taps
    3x10 King, WRU, AOF and AUF
    12" SIRO Filter Press.
    2015 Ford F250 PSD sap hauler
    One Golden named Maggie Cat named Lucy
    Too many Cub Cadets
    Ford Jubilee and several Allis WD's, and IH tractors

    www.mapleandhoney.com

  4. #14
    Join Date
    Mar 2020
    Location
    Springfield, MA
    Posts
    10

    Default

    I made some Maple Sugar with a pint of dark just to see if I could. It only took a total of 30 minutes cooking and stirring so not sure why yours went so long. Ended up with about 11 ounces sugar and another few ounces chunks/nuggets.

    I made up some chocolate chip walnut cookies replacing the regular white sugar but not the brown sugar. Couldn't really taste the maple so next time I'll try replacing both. The chunks were fantastic as an ice cream topping - reminded me of the peanut butter crunch toppings you get on soft serve.

  5. #15
    Join Date
    Jan 2008
    Location
    Hopkinton, MA
    Posts
    1,555

    Default

    Funny this thread popped up as I just made my "worst" batch of sugar today. Like you, Mark, I used a Very Dark, not scorched though. I've gradually tried out darker and darker grades and I think I finally hit the limit. It took 25+ minutes of stirring and it came out like a very thick cookie dough.

    I put it through the food mill to get it to smaller (still very wet) pieces and put it in the oven drying setting at 190 deg. It took about 4 hours and two more trips through the food mill, but I was able to save it. It's good sugar! I'm not using this syrup again, though. It's back to the Dark. I wanted to see if I could save this batch and I'm glad I did, but I don't want to do that again.

    Mark, I use the Kitchen Aid 600 Series with the bowl lift. It handles 1-quart batches well (although today I worked it over). That's about the smallest mixer you can go with. If you can afford to go bigger, then do that.

    For sieve/sifting the sugar I use this food mill. I'm VERY happy with it. I use the largest disc size which is just about 1/8".

    Sean
    Woodville Maples
    www.woodvillemaples.com
    www.facebook.com/woodvillemaples
    Something north of 250 taps
    Mix of natural and mechanical vac, S3 Controller from Mountain Maple
    2x6 W.F. Mason with Phaneuf pans
    Deer Run 125 RO
    6 hives of bees
    Keeping the day job until I can start living the dream.

+ Reply to Thread
Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts