 |
 |
Evaporator Door
I'm insulting the door on the evaporator we built. Just wondering if any one has fitted a piece of stainless steel over the insulation before and how it worked out for you. The last two years we have had the insulation exposed and it did well to last the season.
Fitting a piece of sheet metal over the insulation on my door has been on my to do list for a while. I will get there one of these days.
Once you get it covered up that will be the last time you ever need to worry bout the insulation on the door.
2017 25 taps on buckets got me hooked 1 gallon of sweet
2018 51 taps on 3/16 tubing/ DIY oil tank evaporator 8.5gallons finished
2019 60 taps 7 gallons finished ended season short
2020 New 2x4 divided pan ready to get away from the headache that is steam table pans
10 gage S.S. has lasted 3 yrs maybe 1 more.
5th generation
2 1/2 Buckets
752 gravity
2 new flat pans. Back pan now has 16 V's
Rebuilt the block arch 3x12
Homemade pre-heater,steamhood,float
MES Dolly RO
I used some stainless expanded metal. it warped a little but worked pretty good. Still there after maybe 8 years?
Regards,
Chris
Casbohm Maple and Honey
600 roadside taps
3x10 King, WRU, AOF and AUF
12" SIRO Filter Press.
2015 Ford F250 PSD sap hauler
One Golden named Maggie Cat named Lucy
Too many Cub Cadets
Ford Jubilee and several Allis WD's, and IH tractors
www.mapleandhoney.com
Thanks Fella's we will give it a try
Posting Permissions
 |
|
Reply With Quote