+ Reply to Thread
Results 1 to 3 of 3

Thread: Start /stop gas driven vacuum pump via auto controls

  1. #1
    Join Date
    Mar 2011
    Location
    ontario canada huntsville
    Posts
    42

    Question Start /stop gas driven vacuum pump via auto controls

    I have a 9 hp airblo Honda driven with twin belt drive. With the use of a 2 inch stroke , linear actuator 12 volt ,controlled by a temperature sensitive switch set for 29 degrees to extend the actuator. The extension will also work a dual linkage 1 pull engine back to an idle 2 release a belt tensioner tensioning drive belts . Pump stops, Honda idles all night. Next morning temp device at 30 degrees approx will extend the throttle to full, tensioning belts and away we go. Honda is electric start, has battery. Anybody done this . Pitfalls ?

  2. #2
    Join Date
    Jan 2006
    Location
    Oneida NY
    Posts
    11,583

    Default

    Sounds good, report how well it works when you get in the season.
    Dave Klish, I recently ordered a 2x6 wood fired evaporator from A&A Sheet Metal which I will be converting to oil fired
    Now have solar, 2x6 finish pan, 5 bank 7x7 filter press, large water jacketed bottler, and tankless water heater.
    Recently bought another Gingerich RO, this one was a 125, but a second membrane was added thus is a 250, like I had.
    After running a 2x3, a 2x6, 3x8 tapping from 79 taps up to 1320 all woodfired, now I'm going to a 2x6 oil fired and a 200-425 taps.

  3. #3
    Join Date
    Jan 2014
    Location
    Merrill, WI
    Posts
    61

+ Reply to Thread

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts