For the sawmill, there is likely a sawyer who will come to your location and saw it. If you go that route, I suggest you have the logs placed on 2 rails (a log near each end 90 degrees to where the mill will set) and then have all of the logs on those rails and ready to go. That is how I used to like them when I did custom on site milling (I now only do my own).
Dave Klish, I recently ordered a 2x6 wood fired evaporator from A&A Sheet Metal which I will be converting to oil fired
Now have solar, 2x6 finish pan, 5 bank 7x7 filter press, large water jacketed bottler, and tankless water heater.
Recently bought another Gingerich RO, this one was a 125, but a second membrane was added thus is a 250, like I had.
After running a 2x3, a 2x6, 3x8 tapping from 79 taps up to 1320 all woodfired, now I'm going to a 2x6 oil fired and a 200-425 taps.