This may have been asked before, but I can't find anything on it.

Is there a way to connect 3 6" SS steam pans so they flow like a real "PRO" pan? I was thinking of tubing towards the bottom, but think sealing that would be to difficult with the higher heat. Also was thinking about "notching" the tops of the pans and getting some "channels" welded in that would carry the sap from back to front.

Trying to get some ideas how to make this a "flow" setup and get away from the "dipping".

This is the design I am going with this year. Image stolen from optionguru
evap_-_Copy.jpg

Last year I had a similar tank on it's side with 3 2" pans and built fire under ALL 3. VERY hard to manage and didn't get the GPH that I will get with the vertical setup and brick lining/ramp etc.