If it is metric, measure the diameter in MM The diameter from the deepest thread depth to the opposite corresponding groove and the pitch (mm distance thread to thread. Then you should be able to get a nipple to screw in. Then go Fernco connector and use a valve from there. Good luck.
Dave Klish, I recently ordered a 2x6 wood fired evaporator from A&A Sheet Metal which I will be converting to oil fired
Now have solar, 2x6 finish pan, 5 bank 7x7 filter press, large water jacketed bottler, and tankless water heater.
Recently bought another Gingerich RO, this one was a 125, but a second membrane was added thus is a 250, like I had.
After running a 2x3, a 2x6, 3x8 tapping from 79 taps up to 1320 all woodfired, now I'm going to a 2x6 oil fired and a 200-425 taps.