Search:

Type: Posts; User: Mrk59rsk

Search: Search took 0.00 seconds.

  1. Replies
    28
    Views
    9,995

    Mol, any warping on your stack plate and how...

    Mol, any warping on your stack plate and how thick is it? Thanks.
  2. Replies
    9
    Views
    1,279

    SuperSapper, thanks for the input.I am leaning...

    SuperSapper, thanks for the input.I am leaning toward going thru the top as you suggest. As it so happens I will have one pan 18x34x6 and a full size steam pan I used this year on a block arch for...
  3. Replies
    9
    Views
    1,279

    Thanks for the input Dave. The arch will be angle...

    Thanks for the input Dave. The arch will be angle iron, nice and square hopefully. I do plan on the rear firebox wall being bricks up to approx. 3" from pan bottoms then maintain the 3" distance from...
  4. Replies
    9
    Views
    1,279

    Shaun, early plans are to use 2x2x3/16 angle iron...

    Shaun, early plans are to use 2x2x3/16 angle iron for framing the arch, wanted the 2" to accommodate splits ( 1.25" ) plus Roxul/Rockwool batts (1.5") behind the splits in the firebox. This may...
  5. Replies
    9
    Views
    1,279

    Thanks for the input Mol and Shaun!

    Thanks for the input Mol and Shaun!
  6. Replies
    9
    Views
    1,279

    Planning arch build

    I am in the planning stages for an arch build for next season. My flat pan ( no dividers) will be 18x34x6.
    I am using the pyromatic plans found on this site, a few questions:
    Since the arch is...
  7. Replies
    5
    Views
    768

    Thanks to all for the feedback, looks like I'll...

    Thanks to all for the feedback, looks like I'll be welder shopping!
  8. Replies
    5
    Views
    768

    18x34x6 flat pan,I had the same worries using...

    18x34x6 flat pan,I had the same worries using unistrut,was looking for opinions from others.
    This hobby does bite you hard,may have to take the plunge on some tools. Thanks for the reply and time.
  9. Replies
    5
    Views
    768

    Unistrut for arch frame?

    Don't have a welder or metal working tools, was wondering if unistrut could be used for a small
    2x3 arch? Thanks for any feedback yea or nay.
  10. Replies
    15
    Views
    2,888

    Nice design! I'm new to the forum, live in the...

    Nice design! I'm new to the forum, live in the Western New York area. Could you explain how you secured the insulation to the barrel walls? Thanks!
Results 1 to 10 of 10