Search:

www.farmertec.com
Rebuilt many saws using parts from this supplier.

Thank you.I attended a seminar and that is where the info came from. However Steve did not go in to much detail about it that day. I will reach out to him.
Thanks

Anyone have any information on using a pressure cooker for heating up syrup to the proper temp for cream or sugar?
Thanks Lee

Problem solved! great to know it was a factory problem. It was in the wiring harness were the technicians put in a poor splice job and it melted the wires together.
Thank you all.

I am not sure how to attach photos.

There are separate contactors for motor and air damper control. When primary is burned up it is the circuit that turns on the oil solenoids.

Picked motor up today,no problems with it.

I have checked all connections and changed breaker. Seems to happen when high fire is involved. High fire timer blower damper contactor problem?

Hello,
I have a carlin 701crd oil gun 4 years old. I started having an issue halfway through this past season. At no specific time it would happen.
I would be boiling for maybe 2 hours and...

If you research current standards the goal has been changed to 3 taps per lateral run for the efficiency of high vac transfer to the tap. However there is always a couple of runs with 4 or 5. I am...

If I may ask what is this ?

Anyone getting requests for an order for products for a store in Hong Kong?

Clearwater Bay Stores

I received my email for nys maple association renewal and noticed it is up $15.00 what is the reason?
Thanks

Bascom via phone last week stated
$1.90 for dark robust.
$1.75 extra dark strong.
$.90-$1.10 off,ropy,non filtered.
Hope this helps.

Can anyone tell me a part number or what the pan connector fitting that D & G uses is called?I tried to load a picture.
Thanks16283

No one out there?

If anyone has a Dominion Grimm oil fire raised flue evaporator could you please send me some pictures of the inside of your arch?I would like some pics of the fire box and under the flue pan ramp...

Any one have current prices?

Unless you have a set of torches.When I worked construction in the cheese plants we would have to demo old steel shell silos and would use a small orifice torch tip.Cut right where the two metals...

I would recommend speed 4 to start and if it starts to bog down turn it to 6 I have even had to turn mine up to 10.If you are doing batches 1st one is usually 30 min to finish.Next ones are a lot...

I think it would be an issue with not cooking it long enough.Most recommendations are 22-24 degrees above the boiling point. Also it could be you stopped stirring it to soon.

From experience it sounds like basswood.I burn all popple and basswood

Is there contact info for Highland?

So much for a good run.Gotta love the wind.

If there is no seal I will guarantee that you will have mold show on the top of a portion as they sit.I had this problem as well with caps like you are describing with a 25% fail rate.

Tractor supply