Search:

Is it necessary to have a booster when using a Double Sap Sucker?
Thanks

Thanks for the info

I have 400 taps on about 2100 feet of 3/4 mainline with a mix of 3/16 and 5/16 laterals
I have been using a 115 volt Shurflo but have trouble finding vacuum leaks.
Would a Guzzler work on this...

Has anyone been able to figure out how to control AUF fan from an output from Great Lakes Guardian unit that monitors the stack temp

TAKE A BREATH!!!!!! I think you are over acting.
I didn't say you are wrong JUST stating what I was told.

FYI I was told by my tubing and fitting supplier that many of the 3/16 manufactures are phasing out of producing 3/16 products

Great idea Dr.

How about a battery powered timer to start the generator to charge batteries a a regular basis.

Art Krueger Youtube

I was wondering if anyone has an audible alarm connected to their Guardian Auto Draw that sounds when the systems opens the dump valve.
Thanks

I have a Kubota RTV 900 and I reversed the n
back wheels so tire chains would clear the springs and it works great

Cigar smoke!!!!!!

Working on vacuum filter unit. I have two stainless steel vessels that fit inside one another. The upper vessel will be open on the bottom and will be pulled down on the filters that sit on the...

Purchase a contactor that will operate on 110 volt that would be controlled by your temperature controller but the contactor would be able to handle 220 volts to operated the pump. Look at Grainger...

Thanks for the info

West Summer Sugar. I was wondering were you bought the by pass valve that opens when the pump is off?

I would be afraid of the line freezing unless you drain it when the run stops

I ran high tensile wire through my culvert and then wire tied mainline to wire every 18 inches inside the culvert.

Thanks. Do you use a one handed tool to attach the 5/16 to the saddle 90 degree fitting.

DSD catalog only shows 5/16 saddles with 90 degree barbed fitting and 3/16 with only straight barbed fitting. . I have 3/16 laterals. When you install the 3/16 straight saddles are you suppose to...

I have a trip to State College Saturday. I will be coming from the Ohio/Pa line. I need some supplies. Is there a dealer near Happy Valley?
Thanks

Thanks for info.

I am working on gathering material to build a Shurflo vacuum system. Do you guys suggest using 1/2 or 3/4 PVC fittings. I believe that the Shurflo pumps are built with 1/2 fittings.
Thanks

What is the max height that I could attain with the Shurflo. I need to cross a township road so I would need around 18 feet. I am planning on having near 100 taps ahead of the ladder. It will be...

I am working on vacuum system and wondered if I installed one normally open and one normally closed solenoid valves on the tree side of the Shurflo pump so that when the temp controller shut the pump...