I’m going to have to look. It’s a stainless submersible pump runs on 240 volts.
Type: Posts; User: meadster02
I’m going to have to look. It’s a stainless submersible pump runs on 240 volts.
Has anyone ever experienced this pump all of a sudden not being able to overcome the vacuum pressure?
Is there a rebuild for the pump?
Check your pressure switch it could be sticking.
Pretty slow over here on my side of the hill. Just about the time it gets running temp drops and it shuts off. I'm about 50% of where I ended up last year as well but looks like some runs to come yet.
Congratulations on the great year. We have been froze solid for almost two weeks now and I'm only 2.5 hours north of you guys. currently we are sitting at about half a normal year hoping the weather...
Masport vac pump
How do you go about removing an add after it is sold
also keep in mind your hydrometer is calibrated at 211 degrees so when your bringing syrup off at 217 it will float like its light. do a cold test on it or make sure your syrup is 211 when you test it
I'm running a D&G 600 with an 8x40 membrane not positive of the make. I have never had and issue with it fouling. the first few years I owned it I ran it that hard the whole time because I only had a...
On average we are boiling between 1200 and 2000 gallons and my process goes like this. I haul sap in from two bushes and have one bush at the sugar house so the tank has sap in it when I arrive home...
I'm planning on holding off until at least the first week of February, but I also am only running about 900 taps on three bushes so with two guys we can get tapped in a weekend. That being said if...
Has anyone noticed at the end of the year when removing the cv adapter from the stubby how gummed up they seem to be. When I take them off the vacuum seems to increase a lot almost like it was...
to go 4000 feet your going to need primary voltage from your power company
air operated drum dispenser
Maple expert solutions MES is an app for your phone works great
I use canola and it causes no flavor issue
where did you find your oil filter body and the oil drippers
there is a snap ring on the inside. take that out then the whole thing will twist and pull up out
That works fine when you make a gallon, but when your doing hundreds of gallons that takes a lot of time.
I use syruplabels.com they are great.
I don't think the numbers in your figure are correct the formula is for 100 gallons, so you would remove 33.84 gallons from 100 to end up with 66.16 gallons of 6.5% sap.
Just finished the second batch worked perfectly again.
So far it has worked perfectly. Got a batch ready to go for tomorrow, so we will see how it goes.
oberdorfer 4000 series
1- 2'' tri clamp and silicone gasket
1- 2'' tri clamp to 3/4'' male thread
1- 3/4'' street elbow
2- 6'' pipe nipple
1- 18'' pipe nipple
1-3/4'' cam lock fittings
1-3/4'' elbow
1-3/4'' 3...