Is this pressure switch on the suction or discharge side of the feed pump? If on the discharge side, do you have concerns about cavitation?
Type: Posts; User: Cloverland Maple
Is this pressure switch on the suction or discharge side of the feed pump? If on the discharge side, do you have concerns about cavitation?
What mechanism do you have on the feed pumps to avoid cavitation or aeration? I want to be able to start the RO and "walk away". I have a low pressure switch between the filter and the ProCon, in...
Yikes! Sorry to hear about the misfortune. I have a similar set up with a ProCon 330gph pump fed by a 3/4 hp Flotech. The filters have a flow rate of 10gpm. I didn't want a feed pump that would push...
Thanks, Bowhunter.
Based upon the 15 psi differential, I'll set my low pressure switch (outlet side of filter) to 35 psi. It's feeding a Procon that has a minimum requirement of 30 PSI, so it...
Assumption: 10" 5 micron filter
I'm finishing up a homebuild RO system and want to better understand what to expect concerning a pressure change from the feed inlet to the 10" 5 micron filter and...
We're looking at devices and methods to bottle syrup, and have considered the water jacketed bottlers (which I prefer), coffee urns, and other ideas - many of which have been posted on MT.
I was...
This cause any issues when you were in wash cycle?
Thanks. Nice looking unit. I'm assuming you had head pressure from the sap tank to feed the HP ProCon pump?
I found the multistage pump flow curve to be the downside of using such a pump. But if I understand you correctly, the ProCon is pushing the feed, at the desired pressure, to the multistage, then to...
It's kinda why I am also asking the questions. I can get a Goulds 10GBS10 for rougly $600. The ProCon 600 is only a few bucks less and without the adapter and 2PH motor, all additional cost to me...
I don't know much about the Weber Webtrol. Are you satisfied with its performance?
Were you running these in a series or in parallel?
Several posts on MT suggest users are using ProCon pumps, particularly 330gph for multiple membranes (series or parallel) However, I have not seen much discussion on higher output ProCons or similar...
Could you please explain why? I'm making an assumption that the RO can feed the flow at nearly the evaporation rate, if calibrated. We'll likely RO and store, albeit it would only be for a few hours....
Yes, it sure does. Thanks.
Thanks for the feedback.
The stated increase to the evaporation rate with a flue style pan has my eyes getting big. Wow. That would be quite the improvement. We currently don't have a steam hood,...
I'm looking to do a few upgrades (by replacement) to the syrup pan. The upgrades would be to 304 stainless steel and possibly the design of the pan. We're contemplating constructing a new pan, or...