Figured it out...if you get it off the floor, the thermostat works great. Now it's sitting on my shelf. I think I may buy one of those thermostat plugs...same level as the pumps and want to make sure they don't freeze. Thanks for the help.
Printable View
Figured it out...if you get it off the floor, the thermostat works great. Now it's sitting on my shelf. I think I may buy one of those thermostat plugs...same level as the pumps and want to make sure they don't freeze. Thanks for the help.
Josh - is the floor insulated ?? There are Home Depot products up here with a name like DryDeck.
They are about 3/4" waferboard 2 x 2 squares that fit to each other tongue and grove and have
plastic bottoms with dimples that create an air gap under them about 1/4". Cut to fit the room with a table saw.
Pretty durable and not very expensive for the area of an RO room. They make a pretty big difference in
our basement too !
Never heard of it, but sounds interesting and will check it out. I had the floor insulated, but no plywood backing, so it all fell down and I pulled out over the summer.
here's a link to the Dry-Core product
http://www.homedepot.ca/product/2-ft...-system/931386
$ 7. a section up here, likely less in the USA
Might do the job for $50.
I just noticed they have a new product
http://www.homedepot.ca/product/barr...or-tile/986663
same top as the one above but with styrofoam insulation underneat.
I just might run down to HD right now and get a few peices of this. Going to set up the RO today.