Printable View
I'm curious to see what others have for pulley setups or hangers for their steamaway and hoods. I have a 3x8 steamaway pan on my 3x12 evaporator and feel like the 1/4" coated cable is a little overkill for the weight of it. Post pictures of what you have please, looking for ideas to make my setup easier. Long term I want to install I-beam with rollers and electric lift to lift then slide the steamaway over for cleaning.
Simple set up we are using with SS cable and eyebolts and a boat winch.
Attachment 19128
JR,
I have some pictures on here somewhere? Old post. You might try searching. I also use a hand crank boat winch and a rolling frame work to support the steamaway and or the rear pan and hood.
Humm these aren't very good. There is a frame not shown below the rails. Maybe I can find others?
http://i233.photobucket.com/albums/e...-10tracks3.jpg
http://i233.photobucket.com/albums/e...-10tracks2.jpg
http://i233.photobucket.com/albums/e...-10tracks1.jpg
http://i233.photobucket.com/albums/e...22-10WRU_5.jpg
Found them Just my 2 cents.
Regards,
Chris