Saddles Upside WRONG, and Twisting

Ok, I know this isn't ideal but, I installed a roadside mainline last year. One straight shot, about 80 taps, 200 yards. I used small (1/2") mainline (didn't know any better), and electric fence wire with strainers at each end. It is right in front of a neighbor's house (the neighbor that let me tap his trees) so I can't leave it up. I coiled up the mainline last spring, now I am putting it back up. I used the saddle type connectors to connect my laterals into my mainline. More than half of them are upside down, but not all of them. It seems like my line has twisted. Any cutesy tricks on how to twist the mainline so the saddles are on top again?!?! Seems like I'll have sitting sap and frezing issues if I don't correct this...

I fight it every year, but only on 5/16 lines on road side trees.
If I go around the trees the wrong way the drops will be upside down.
I have to watch real close. And I mark the trees.
Chris

The supplier I use had the best idea so far, refit the saddles properly, tape up the old holes. They even had rubber plugs that can be fitted into the hole, then taped over. Sounds good for now, but I can't do that every year...:confused:

I dont think that I would be putting tubing up every year and then taking it down every year. I would move onto another property to tap. Too much work.

Quote:

---

Originally Posted by AGR1093

The supplier I use had the best idea so far, refit the saddles properly, tape up the old holes. They even had rubber plugs that can be fitted into the hole, then taped over. Sounds good for now, but I can't do that every year...:confused:

---

Rubber plugs for Mainline? Now I have a hundred Questions.

What size? ( I have both 5/16 & 7/16 )
Will they work under Vac. and with what success?
Where can you get them?
Just tape them in ?

Ok, 4 Questions for now.

AGR I wrap the hole with electrical tape and put a hose clamp over it. They don't leak even with over 20" of vacuum. If your not using vacuum on yours you don't want mainline over 1/2" diameter. You have a better chance for some natural vacuum with the smaller line. You may want to use a manifold that you cut in instead of the saddles. You just loosen the clamps and twist the manifold into the position want it in.

try twisting back by attaching to a saddle (with 3/16 nylon rope) , wraping the saddle 2 times in the direction you want to untwist and side pull as needed to tension line and hopefully untwist. Might be worth a try. When you get it up properly, after going around the tree 2x come back to the mainline and tie a clove hitch around the main in the direction that will hold it there. You can then use a couple wraps of electrical tape to hold the clove hitch, but if tight you should not need it.

Ethan I just ran in this exact same issue. You uncoiled the mainline. I ran some used mainline in the new expansion. One branch we uncoiled the 2nd we unrolled. The coiled one did this. And there was no way to straighten it. So I drilled new saddles and put hose clamps with a chunk of rubber between the clamp and the mainline to plug the old holes. Just a flat piece from lowes.
The rolled one worked perfect.

Thats wy I use saddles with barb fittings.....................YEA I know They suck, dont work and restrict flow BUT all I ever read about the saddle fittings is they Suck, leak, break easy and there expensive. Now if mine get twisted over time I walk up and twist them stright:) I have some saddles in the parts bins I think I will start my next camp fire with them.

if its on vaccum, does it really matter if they are on the bottom? I mean there needs to be air space in the mainline for vacuum anyway