Auto Draw off Parameters

[mapleman3]

Ok I'm building a marcland knock off for myself... I am looking for all the parameters that are set on the controller, not just the temps but all the settings like the integral, derivative, offsets all that.. anyone care to take the time and scroll through and write them down?

[jrthe3]

jim i would like to build my own also could you list the parts you used and maybe where you found them

[Grade "A"]

I tried to set the PID parameters with no luck, it would just click and not work right. I ended up getting a controller that you can shut the PID off and then it would open and close at the set temp. A PID will open early so that it will not overshoot the set temp by alot.