Russ
11-30-2004, 10:37 PM
OK, here's another concept to discuss. We don't have all of our taps on the vacuum system; inevitably there are pockets of maples that should be tapped but cannot be economically added to the pipeline. However, there is no bigger time waster than running from tree to tree collecting 2-3 quarts from each tree into a 5 gallon pail or jug, then transferring the sap into a gathering tank. To solve this, we put up what we call bag networks.
Basically using the same supplies from the vacuum system, we'll string a taut lateral at a downhill angle (either naturally or manmade) among 4-6 trees. The downhill tree is usually along side the logging road/ATV trail. On the bottom tree, we use a standard metal spile and hang a holder and bag, and put a drain line off the lateral into the bag. Voila'!! Bags are almost always full (sometimes running over) every day. We plan on pulling a gathering tank trailer with the ATV and drive from bag to bag to collect. In essence, we're collecting from 400-600 trees using 100 bags, right along the trails! Only on one day last year did we really need to collect twice in order to prevent massive sap loss.
Does anyone else do this? I noticed that when I was pulling taps (we use the smaller 5/16" Ecolo taps) there was a fair amount of sap still in the drop lines and laterals due to no venting; once I pulled a tap, the lateral drained quickly. Since we are not running vacuum on these networks, should we be cutting/drilling a small vent hole on the highest drop line to promote faster draining?
Basically using the same supplies from the vacuum system, we'll string a taut lateral at a downhill angle (either naturally or manmade) among 4-6 trees. The downhill tree is usually along side the logging road/ATV trail. On the bottom tree, we use a standard metal spile and hang a holder and bag, and put a drain line off the lateral into the bag. Voila'!! Bags are almost always full (sometimes running over) every day. We plan on pulling a gathering tank trailer with the ATV and drive from bag to bag to collect. In essence, we're collecting from 400-600 trees using 100 bags, right along the trails! Only on one day last year did we really need to collect twice in order to prevent massive sap loss.
Does anyone else do this? I noticed that when I was pulling taps (we use the smaller 5/16" Ecolo taps) there was a fair amount of sap still in the drop lines and laterals due to no venting; once I pulled a tap, the lateral drained quickly. Since we are not running vacuum on these networks, should we be cutting/drilling a small vent hole on the highest drop line to promote faster draining?