TDVT
03-23-2008, 09:20 AM
Not being a native Vermonter, I wasn't born with a general working knowledge of sugaring & all the equipment, but I'm working on catching up.
After reading/searching through many threads, I have a general question about the various types & configurations of flue pans. The increased surface area makes perfect sense but I'm curious about all the variations to that end.
I have seen drop-flue pans around here but from the top only, never out of the arch. I DID find some good pics of one installed, taken from the bottom. But I see there are raised flue, hybrid drop/raised, drop tube, etc. Are there more? Pleated bottom?
I would love to see some section drawings/pics if anyone has any of the various types.
Also, do they not burn because there is always cooler sap flowing down? Or do they get cruddy at the very bottom? Do any draw off at the very lowest point by any sort of cross drain-tube?
Thanks, Ted
After reading/searching through many threads, I have a general question about the various types & configurations of flue pans. The increased surface area makes perfect sense but I'm curious about all the variations to that end.
I have seen drop-flue pans around here but from the top only, never out of the arch. I DID find some good pics of one installed, taken from the bottom. But I see there are raised flue, hybrid drop/raised, drop tube, etc. Are there more? Pleated bottom?
I would love to see some section drawings/pics if anyone has any of the various types.
Also, do they not burn because there is always cooler sap flowing down? Or do they get cruddy at the very bottom? Do any draw off at the very lowest point by any sort of cross drain-tube?
Thanks, Ted