Pump Speed

[OGDENS SUGAR BUSH]

does anyone know the formula for motor pulley speed = pump pulley speed??


RICH

[Russell Lampron]

Rich,

What kind of pump are you asking about? If it a vacuum pump I don't know if there is a specific formula. It would depend on the rpms of the motor and desired rpms for the vacuum pump.

Russ

[tuckermtn]

I seem to remember in the Grangier catalog there was a good chart talking about pully/sheave size on one end, size on the other, and different charts for 1750 vs 3400 RPM electric motors...not sure if you can access it online or not though...

[petersp22]

I had to do similar math to re-pully some old woodworking equipment

multiply your engine/motor rpm time the pully diameter and divide that answer by the driven pully diameter to get your driven shaft rpm.

(input rpm*input diameter)/driven diameter=driven rpm

I think I got that right... I did it with a spreadsheet.

[OGDENS SUGAR BUSH]

thanks everyone

PETER had the answer i am looking for. i tell you this site can answer every question out there again thanks to all

RICH