1 1/4 tubing

[western mainer]

I will be going about 1500' with 1 1/4 tubing, will 12.5 g wire work or do I need to use 9 g
Thanks Brian

[Moser's Maple]

Do 2 runs of 12.5 gauge. Tighten it up as much as you can. Stake where needed. You’ll be shocked how stiff it is.

[BAP]

Make sure it’s the 12.5 gauge High Tensile wire not regular 12.5 gauge.

[western mainer]

Yes ,That's all I use is the high tensile

[Russell Lampron]

I used one strand of 12.5 high tensile wire to support a 1.25" pipe that's 1500' long and haven't had any problem with the wire breaking. It does have to be tied back and supported more than a smaller pipe though.

[mellondome]

I only use one strand of high tensile for 1.25.

[maple flats]

I also used one strand of 12.5 HT on both 1.25" and 1.5" on a 1600' wet/dry and used side ties as needed. Pull it super tight, then tighten it more. I used 3 crimp sleeves at each joint, never tried fewer to see if they would slip.