Motor schematicsq

[halladaymaple]

Looking for motor schematic for a surge heavy duty electric motor. It is a 3.6 hp. I can't read the motor badge as it is all scratched up. I'm not sure if the previous owner had it wired for 110 or 220. I have attached a picture of the badge. If someone could send me a link or tell me wiring for 110 and 220 that would be appreciated.

[Wanabe1972]

Can you run it high voltage? It looks like you can read that plate. It's says that sucker draws 32 amps at 110v .

[Brian]

the information is in the lower rt hand corner of the plate it tells rotation and high or low voltage. your camera should make the pic so you can read it from the plate. All I see High voltage ccw black-R3? White-T8 Blue-P1 cw Brown-? Black-P2 White-T-8 From the pic. If you remove the cover you should know if it is wired high or low.

[halladaymaple]

the information is in the lower rt hand corner of the plate it tells rotation and high or low voltage. your camera should make the pic so you can read it from the plate. All I see High voltage ccw black-R3? White-T8 Blue-P1 cw Brown-? Black-P2 White-T-8 From the pic. If you remove the cover you should know if it is wired high or low.

I will try and take a better pic. Man your eyes are good, can't see any of that. The AC cable is just black white and a ground. I want to run it on 220 1750 rpm.