PDA

View Full Version : Firebricking


Woodsymiles
03-16-2016, 11:00 PM
Trying to figure how to brick this thing, raised flue. Doing board and 2" bricks on front, 2" brick siding in back, blanket on vermiculite in the back. 8"-12" space in back for draft. Trying to figure front ramp, stood some brick up to see what it looked like.
Woodsymiles
03-17-2016, 09:05 AM
13843Trying to figure if the area at the rail needs to get filled in or left open. Not sure why pictures are loading sideways either.
Woodsymiles
03-17-2016, 09:17 AM
Not sure how to brick this at the ramp leaving front of arch. Flue pan starts before ramp and the rise of ramp is very low. Not sure why pics are loading sideways.
Cedar Eater
03-17-2016, 10:48 AM
13843Trying to figure if the area at the rail needs to get filled in or left open. Not sure why pictures are loading sideways either.

The pictures are loading sideways because you didn't rotate them 90 degrees before sending them.
Woodsymiles
03-17-2016, 02:52 PM
Pictures are correct on phone. I'm going to put up some more pics, I got some of the bricking figured out.
Rock Bottom Maple
03-17-2016, 03:04 PM
check out my "one brick short of a full lo...." thread. It is not the same arch. But may give you some ideas. Good luck.
Woodsymiles
03-17-2016, 04:51 PM
This is how the front got done...still have some patching and the back
Woodsymiles
03-17-2016, 04:51 PM
check out my "one brick short of a full lo...." thread. It is not the same arch. But may give you some ideas. Good luck.

Looks good, nice job!