View Full Version : sap sight glass indicator
KING MAPLE
10-24-2015, 05:32 PM
Any ideas on how to build a sap glass indicator in the sugar house at the holding that feed the evaporator ????
either in the tank or in the feed line....I have a 90 gal stock tank as a reservoir...
jimsudz
10-24-2015, 06:02 PM
Larry all you have to do is put a tee off the tank with a clear piece of hose going up and off the end of tee a hose going to your float box.Make sure the clear hose is higher than the tank. jim
BreezyHill
10-24-2015, 06:12 PM
next to or behind the clear tube put on old tape measure tape. use a red zip tie to mark the point where you need to not feed the fire any more wood. Yellow for a 30 minute warning, black at the full point and a blue that is loose to move with the level by hand if you need one to mark the level for a quicker view through the steam.
Use colors as you wish of course.
You will want to have something in the end of the hose to keep it clean but allow a small amount of air to pass so you get accurate readings.
Good Luck!
Ben
Powered by vBulletin® Version 4.1.7 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.