PDA

View Full Version : Vent for homemade spout


jake22si
03-06-2013, 02:08 PM
I asked this in my other thread but, can I just drill a hole in the top of the copper 90 to allow it to vent? Unfortunately as it is right now it is a very drippy spout. 7220
DonMcJr
03-06-2013, 02:55 PM
If you do I'd have an extra one ready incase all it does is leak out of the hole...

The valve controls the flow so unless you have it full open it should vent itself...
PeddlerLakeSapper
03-06-2013, 03:43 PM
You need to put the elbow before the valve. You have to much pipe/elbow after the valve for it to clean out quickly.
jake22si
03-06-2013, 05:43 PM
I'm an idiot, it works fine after I soldered it on.
DonMcJr
03-06-2013, 05:52 PM
I'm an idiot, it works fine after I soldered it on.

LMAO! Try Copper Piping a whole house, turn the water on...then have your boss say, "Hey...are you gonna solder these 2 joints?" and he was right and the flux was actually sealing them!
jake22si
03-06-2013, 09:43 PM
Haha, that could suck if it went unnoticed.
LMAO! Try Copper Piping a whole house, turn the water on...then have your boss say, "Hey...are you gonna solder these 2 joints?" and he was right and the flux was actually sealing them!