looking for a part for a surge Alamo 100

[maple connection]

I hope everyone is having a good season or about to start a good season. I picked up a used Surge Alamo 100 and installed a 13 Hp honda engine on the frame work. I was doing the finishing touchs to the oilers and noticed some play in the shaft. I took the end plate off oppose to the pulley side and found that a bearing went out somewere down the line and locked up because the hole were the bearing should be pressed in is oval and worn out from the bearing spinning:cry: If anyone know where I can get a new or used end plate, I would greatly appreciate the info.
Thanks, Kevin

[noreast maple]

Can you just shim the slop in the hole? like maybe with some jb weld or something lie that to get you through this year? Ive used jb weld on a wornspindle axle to make bearing tight on my tri axle dump truck and worked like a charm .