OneLegJohn
01-20-2013, 08:14 AM
Little help would be appreciated. I'm looking for the flared high pressure hose fitting, with the O-ring. I am going to run two (2) posts on one unit. I do not want to restrict the flow to the second tower by using the smaller concenrate hose. That would cause the first membrane to take most of the burden. It would likely foul up faster. I know it is going to happen any way, I just don't want to make it worse with poor engineering.
Does anyone recommend plumbing the two towers with the ability to bypass one post? I was thing it would give some flexibility for small sap runs, isolated wash process, or membrane performance testing. Is my logic flawed? What type of valves can I use on the high pressure side?
64066407
Does anyone recommend plumbing the two towers with the ability to bypass one post? I was thing it would give some flexibility for small sap runs, isolated wash process, or membrane performance testing. Is my logic flawed? What type of valves can I use on the high pressure side?
64066407