will a 4x 8 sheet work for this

[500592]

can i make a 2x4 pan with a 2 foot syrup pan and a 2 foot drup flue pan with either 4inch or 6inch flues out of a single 4x8 sheet of stainless and if someone could attach a plan for ait i would be very gratefull.

[jrgagne99]

Depends on how many flues you want. Do the math!

[802maple]

I am not trying to be a wise$$s but if you want just one 6 inch flue it will be enough.

[TimJ]

How high do you want the sides?

You can easily make a flat syrup pan with 6" sides. Even up to 12" sides I think.

If you want a flue pan you are going to have one flue of about 5" deep. 6" sides.

Unless you feel like cutting and welding some pieces left over form the syrup pan - in which case you could get 2 drops.

(My math might be a little off - just draw it out on paper)

[PapaSmiff]

I have a cutting sheet for a flat 2x4 pan with dividers in the following thread.

http://mapletrader.com/community/showthread.php?t=13682

I used the entire 4x8 sheet with 10.5" sides and two dividers. I don't see how you could get flues out of the same 4x8 sheet.

[SapZilla]

can i make a 2x4 pan with a 2 foot syrup pan and a 2 foot drup flue pan with either 4inch or 6inch flues out of a single 4x8 sheet of stainless and if someone could attach a plan for ait i would be very gratefull.

Are you trying to make three separate pans? Do you own a calculator? Do you know that a 2x4 flue pan would use more then two of those sheets just to form the main body of the pan? That doesn't even include the endcaps or the dividers... good luck...

[500592]

ok my very very rough estamites were very wrong i my fust go with the copper water hammer aresstors