Picked up some stainless today, need to make "plugs"

[GramaCindy]

Hey anyone that can help….I have a Mason 2x4 and have decided that keeping the gradients seperate between boils works better for me. How do I go about cutting a piece of stainless that is 4" x 10" in half the long ways? I hear it is very difficult to cut. I need to make two "baffles" or plugs for my divided pan.

[jrthe3]

i would find a near by metal fab shop and see if they would shear it for ya if not i would use a metal cutting blade in a circler saw or a angle grinder

[Kev]

its not to bad with an angle grinder. just use the thinest cut off blade you can find for the grinder.

[metalhead62]

it will cut with a grinder u will just use more blades and it will take a little longer but not much of either

[GramaCindy]

Thanks everyone! Will try the metal fab shop first.;)