Amber Gold
01-11-2011, 01:33 PM
I'll be putting my RO through a test run either this weekend or next and I have the following questions.
Is it OK to put tap water through the RO? I want to make sure water's going where it's supposed to when I turn valves.
Should I run a benchmark? These are used membranes and Leader told the previous owner they are in the 180 gph range.
At this stage, can I tell if they'll pass sugar? They were slightly frozen before I relocated them to the house.
Do I need to put the membranes in to do a test run?
What do I need to drain when I'm done? I will not be heating the room until maple season. I'm guessing the membrane housings and piping...do the pumps have drain plugs on them? Is there anything else?
Thanks
Is it OK to put tap water through the RO? I want to make sure water's going where it's supposed to when I turn valves.
Should I run a benchmark? These are used membranes and Leader told the previous owner they are in the 180 gph range.
At this stage, can I tell if they'll pass sugar? They were slightly frozen before I relocated them to the house.
Do I need to put the membranes in to do a test run?
What do I need to drain when I'm done? I will not be heating the room until maple season. I'm guessing the membrane housings and piping...do the pumps have drain plugs on them? Is there anything else?
Thanks