maple flats
12-24-2010, 11:51 AM
This morning I finally turned on the solar power to my sugarhouse. I actually tried the last 2 days but with limited sun and ice/snow on the panels prevented enough power generation to start up. I had to get a longer handle on a broom to clean the array. Usually just a little sun and snow slides off, but this time it started as freezing rain which prevented the snow from sliding and I could only reach the lower 3/4 of the array using the broom I used with the panels I used last year. Those panels are now headed to my house and my new, larger array is working.
Last year I only had 300 watts, a low efficiency charge controller, a cheap inverter and 4x6V batteries. Even with that I could run my lights and high pressure blower for 5 hrs in daylight before having to start the genny.
Now I have 740 watts (to start), a high efficiency MPPT charge controller, 8x6V batteries and the top of the line inverter. I sized the controller and the inverter for lots of grow room, I can grow up to 5000 watt array by just adding more panels and upsizing 2 -20' wires. The inverter will give me up to 6000 watts but I will not use that much until I get my eventual battery bank. This one is too small, but I can draw plenty enough to run the sugarhouse well into the night before needing to run the genny. My old set up was 300 watts x ~60% controller efficiency X ~65% inverter efficiency X 95% transformer efficiency (yes, I needed a trans to make 120V. The new set up is 740 watts x 97% efficiency controller x 96% inverter efficiency and no transformer needed. I also get better efficiency into the controller. Last year I had to go 24V in for a 24V battery bank, this new one is nominal 96V in for a 48v bank. The higher voltage means less line loss for the 240' from the array to the sugarhouse. I used to lose about 5% but now I should lose under 2%. Now I can't wait to use it while boiling. Is it spring yet?
Last year I only had 300 watts, a low efficiency charge controller, a cheap inverter and 4x6V batteries. Even with that I could run my lights and high pressure blower for 5 hrs in daylight before having to start the genny.
Now I have 740 watts (to start), a high efficiency MPPT charge controller, 8x6V batteries and the top of the line inverter. I sized the controller and the inverter for lots of grow room, I can grow up to 5000 watt array by just adding more panels and upsizing 2 -20' wires. The inverter will give me up to 6000 watts but I will not use that much until I get my eventual battery bank. This one is too small, but I can draw plenty enough to run the sugarhouse well into the night before needing to run the genny. My old set up was 300 watts x ~60% controller efficiency X ~65% inverter efficiency X 95% transformer efficiency (yes, I needed a trans to make 120V. The new set up is 740 watts x 97% efficiency controller x 96% inverter efficiency and no transformer needed. I also get better efficiency into the controller. Last year I had to go 24V in for a 24V battery bank, this new one is nominal 96V in for a 48v bank. The higher voltage means less line loss for the 240' from the array to the sugarhouse. I used to lose about 5% but now I should lose under 2%. Now I can't wait to use it while boiling. Is it spring yet?